Turbo simulation mode

While simulating a 3d Milling project in CAM system you can use the turbo simulation mode. This mode is turned on by checking the Turbo mode button at the Simulation panel. In turbo mode simulation speed increases dramatically, especially in the Wire display mode. So you can easily backplot huge toolpaths even on low-end PCs.

By now Turbo mode supports only 3 axis milling. There is no support for 3+2 and 5 axis milling as well as turning. The turbo mode resolution is controlled by the Tool/Model tolerance slider in the Simulation Tolerance dialog. The dialog appears after pressing the Tolerance button at the bottom of the Simulation panel. The model resolution varies in 125-250-500-100-2000 ranges. The default resolution is 500x500 dexels.