The ways of the holes machining

Hole machining operations realizes the wide range of the holes machining cycles. The cycle selection is performed on the <Strategy> page of the parameters dialog.

The next cycles are supported:

• Drilling cycle (G81, W5DDrill(481))

• 2025-08-26_06-06-20_Drilling cycle (G82, W5DFace(482))

• 2025-08-26_06-06-20_Drilling with chip removing cycle (G83, W5DChipRemoving(483))

• 2025-08-26_06-06-20_Drilling with chip breaking cycle (G73, W5DChipBreaking(473))

• 2025-08-26_06-06-21_Tapping cycle, tapping with chip breaking and removing (G84, W5DTap(484))

• Drilling cycle (G85, W5DBore5(485))

• 2025-08-26_06-06-21_Drilling cycle (G86, W5DBore6(486))

• 2025-08-26_06-06-21_Drilling cycle (G87, W5DBore7(487))

• 2025-08-26_06-06-21_Drilling cycle (G88, W5DBore8(488))

• 2025-08-26_06-06-21_Drilling cycle (G89, W5DBore9(489))

• 2025-08-26_06-06-21_Thread milling cycle (W5DThreadMill(490))

• Hole pocketing cycle (W5DHolePocketing(491))

See also:

Types of machining operations

Hole machining operations