Application Area:

ENCY Tuner can be launched with a set of parameters from the command line.

List of commands:

/t *full path to NC file* - open ENCY Tuner with NC file, you can open several NC files, example launch from command line mtuner.exe /t C:\NCfilec\file1.nc /t C:\NCfilec\file2.nc

/i *full path to interpreter* - open interpreter in ENCY Tuner, example mtuner.exe /i C:\interpreters\interpreter1.snci

/p *full path to postprocessor* - open postprocessor in ENCY Tuner, example mtuner.exe /i C:\Postprocessors\Postprocessor1.sppx

/o *full path to project* - open project file in ENCY Tuner, you can open *.stcp, *.stc *.snct *.stms projects, example mtuner.exe /o C:\ProjectCAM\ProjectCAM1.stcp

You can run with all parameters at the same time.

Note. ENCY Tuner works with three *.exe files, mtuner.exe, stuner.exe, ltuner.exe, any of them will launch ENCY Tuner, you can launch all of them with parameters. If the ENCY Tuner is already run, then launching these *.exe files will add a new tab to N ENCY Tuner, with parameters or an empty project if launched without parameters.